Disassembly Of The Centre Body And Impeller 2 - Elmo Rietschle G-Serie Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
8.6

Disassembly of the centre body and impeller 2

▪ Carefully loosen the centre body (072) using a flat-bladed screwdriver and pull
it off.
▪ Remove the dowel pin (071).
▪ Remove the radial shaft seal (097) from the centre body (072) and note the in-
stallation position.
▪ Pull the sleeve (134) off.
▪ Mark the installation position (blade direction) of the impeller (027) for later as-
sembly.
▪ Mark the impeller (027) as impeller 2.
▪ Pull the impeller (027) off.
▪ Remove the feather key (006) using a pair of pliers.
▪ Pull the washer (127) off the rotor (005).
31 / 64
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Disassembly
09.2013 · 610.44495.40.320
8