Rear Panel Connector Description - Cebora WIN TIG AC-DC 270T Kurzanleitung Für Installation Und Betrieb

6.2

Rear panel connector description

For connectors CN1, CN2, CN3 and CN4 refer to section 13.4.
Item No 394395396
M Shuko cooling unit socket maximum power 230Vac 500W
O Fuse holder fuse T 2A/230V – Ø 5x20 mm
N Cooling unit pressure switch socket this socket manages
the cooling unit pressure switch and unit recognition.
Socket M is used exclusively to connect cooling unit
the integrity of the welding power source or lead to operating anomalies. CEBORA declines any responsibility for improper use of the power
source and the accessories connected to it.
Robot WinTIG power sources can be used with a cooling unit. We advise a cooling unit for the following applications:
- Torch longer than 5 m
- TIG AC welding
- high-power welding.
The cooling unit is supplied by the power source. When the power source main switch is set to "1", the cooling unit is ready for use. For more
information on the cooling unit, consult the relevant instructions for use. The cooling unit is disabled according to the default factory setting.
The cooling unit is optional on 394 power sources. It is supplied as standard on other power sources.
3301229
CN4
CN5
WARNING
GRV12 Item No 1683 to the welding power source. Connecting other devices could affect
Item No 381
External emergency and Varc Kit Item No 449.
Ethernet port
Power supply kit for external Wi-Fi router Item No 451
17/21