Absaar SL 30 Bedienungsanleitung Seite 15

15
Installing the Wheels:
10. FUSES
If the breaker releases upon overload, push the breaker back in until it clicks into place.
Note: please wait at least 2 minutes before attempting to reset the breaker (required cooling time).
All chargers feature an additional thermal safety circuit. This thermal safety circuit protects the charger from extreme
overload and overheating resulting from improper operation. In such cases, the charger will power off automatically
and then back on again after cooling down for approx. 10 to 15 minutes.
If the polarity is reversed, the fuse will blow and will need to be replaced. You can find it behind the black fuse holder
cover on the back panel of the device. Spare fuses are supplied with the device.
The charger can also power off if the battery is exceptionally discharged and demands a very high charging current.
If your device features a current selector switch, please start the charging process on level 1 or 2. After approx. half
an hour you can increase the charging current.
11. kEEP yoUr bAttEry in good condition
You can significantly extend the battery life by following these tips:
Check the electrolyte level monthly and, if necessary, add distilled water. The charging status can be controlled with
a densitometer. Do not allow the battery poles to become sulphatised. Clean the poles regularly and apply a little
grease. If you only drive short distances or in town, your battery becomes extremely loaded. If you use your vehicle
rarely, the battery is subject to self-discharge. You should therefore regularly check the optimum charging status of
your battery to assure a long battery life. Regular maintenance translates into cost-effectiveness.
Insert the screw through the wheel. Place the 10mm washer
over the screw.
Insert the screw with the wheel into the housing and fix it with
the star washer and nut.
EN