Video Operations; Playing Video Sources; Recording With A Video Deck - Teac AG-D8900 Bedienungsanleitung

VIDEO OPERATIONS

Playing Video Sources

Note:
For playing video software using a certain Surround
Effect function, refer to the "SURROUND EFFECTS"
section.
1
Source Indicator Lit
POWER ON
2
VIDEO 1
DVD(2CH)/VIDEO 3
or
DVD(6CH)/VIDEO 3
3
TV Monitor
1. Select the VIDEO 1, VIDEO 2 or DVD (2CH)/VIDEO 3
mode by turning the FUNCTION selector, or press
the 6CH DIRECT INPUT button to select the
"VID3/6CH" mode.
2. Play the component corresponding to the FUNCTION
selected.
3. The picture from the video source can be seen on the
TV and the sound from the video source will be
heard from the speakers.
DVD 6-CH DIRECT INPUT
If you own a DVD player equipped with 6-channel
output, this receiver allows you to obtain the full
surround sound impact of DVD source material
featuring multi-channel encoding. Since the source
signals are digital and each channel is input
independently, the resulting ambiance is far superior to
what can be achieved with conventional surround
sound systems.
When "VID3/6CH" (DVD 6CH) is selected, the source
levels of individual channels (L, C, R, LS, RS, SW)
cannot be adjusted. However, the Center and Rear
level can be adjusted from –10 dB to +10 dB (in 1 dB
steps) using the CENTER and REAR LEVEL up/down
buttons on the main unit and remote control unit.
: Video signals
: Audio signals
2
VIDEO 2
3
Speakers
– 18 –

Recording with a Video Deck

Tape Dubbing (from VIDEO 2 or DVD/VIDEO
3 to VIDEO 1)
1
Source Indicator Lit
POWER ON
3
VIDEO 1 DVD/VIDEO 3
Recording
1. Turn the FUNCTION (source) selector to select the
VIDEO source (VIDEO 2 or DVD/VIDEO 3) to be
recorded.
When DVD/VIDEO 3 is selected, make sure that
"VID3/2CH" appears on the display.
Make sure the TAPE 2 MONITOR button is set to
OFF.
2. Play back the source (VIDEO 2 or DVD/VIDEO 3).
3. Operate VIDEO 1 for recording. Video/audio signals
from the selected VIDEO component (VIDEO 2 or
DVD/VIDEO 3) can be dubbed to VIDEO 1.
Note:
When tape dubbing is performed, be sure to connect
the LINE OUT (analog audio output).
S.A.V.E. (Second Audio Source for Video
Editing) SYSTEM Function
This feature lets you replace the sound from a VCR with
sound from an AUDIO source such as CD during video
signal dubbing.
1. Select the video source (VIDEO 2 or DVD/VIDEO 3) by
turning the FUNCTION selector. Wait for more than 5
seconds and then select the audio source with the
FUNCTION selector.
2. Operate the selected video component and audio
component for playback, respectively.
3. Now you can watch the picture from the video
component on the TV, and listen to the sound from
the audio component through the speakers.
4. Operate VIDEO 1 for recording.
: Video signals
: Audio signals
2 2
VIDEO 2
Playback Playback