Weh TW57 Betriebsanleitung Seite 22

AE Operating instructions
Disconnecting a TW57 with bail actuation, flexible wire rope and locking device
Figure 14
Figure 15
Page 22
MD-10058-L51-R1.1.0-03
Î
Fold the actuation bail (Pos. 6) downwards and pull at the
locking device (Pos. 8) at the same time (Figure 14). The
flexible wire rope will fold upwards and the clamping jaws
will open.
Note: The safety peg (Pos. 5) at the connector must be
fully retracted. Actuating before the equipment is fully
depressurized and before the safety peg has fully
retracted can result in damage to the safety peg.
Î
Pull the connector straight back (Figure 15). Doing so will
prevent any damage to the front seal caused by any sharp
edges on the cylinder valve.
Attention: In the event that you cannot remove the
connector:
- Wait a few moments
- Never use excessive force
- Do not use any tools (e.g. hammer)
- Make sure that the connector is depressurized. The
safety peg (Pos. 5) at the connector must be fully
retracted.