HEIDELBERG Suprasetter A52 Installationsanleitung Seite 48

Installation
Fig. 25 Transport safeguard: Load table
Note: Stand-alone devices can have two cable ties. In this case, loosen and remove both
cable ties.
Fig. 26 Transport safeguard: Chassis top
Fig. 27 Transport safeguard: Chassis bottom
46
Loosen the screws of the four brackets (Fig. 25/1)
and remove the brackets.
Cut open the cable ties (Fig. 25/2) and remove
them.
Transport safeguards for the chassis:
On the left and right side of the Suprasetter (i.e.
2x2 transport safeguards): Loosen screws 3 to 4
turns from above (Fig. 26). Do not fully unscrew
these screws!
Remove the screws (Fig. 27) with 2 washers each
at each chassis corner.