Fig. 17 Transport safeguard: Roller
Note: Figure shows DTL.
Fig. 18 Transport safeguard: NIP roller and VCT bar left
Fig. 19 Transport safeguard: Feed motor
Suprasetter A52/A75 – Installation
Cut open and remove the cable tie securing the
roller (Fig. 17/1).
In addition for a semi-automatic device: Cut open
and remove the cable tie securing the gate.
Cut open and remove the cable ties for NIP roller
(Fig. 18/1) and VCT bar (Fig. 18/2).
Loosen the four screws (Fig. 19/1) of the feed
motor and remove the bracket.
Installation
43