Installation Of The Suprasetter - HEIDELBERG Suprasetter A52 Installationsanleitung

Installation of the Suprasetter

Fig. 4 Suprasetter rollers and feet
Risk of injury from buckling feet when pushing the machine
The feet (Fig. 4/1) are rubber-coated to prevent "wandering" of the machine.
Once on its feet, the Suprasetter may no longer be moved! Moving the machine
by force will bend the feet.
Fig. 5 Spirit level, rear
Suprasetter A52/A75 – Installation
Wheel the Suprasetter to its final position. Twist
down the three feet of the cast base (Fig. 4/1) until
the Suprasetter lifts and the rollers can be moved
freely (ca. 5 mm between rollers and floor).
Use a spirit level when aligning the Suprasetter by
adjusting the height of the 3 feet.
WARNING
Place a spirit level on the milled part of the cast
chassis and align it in horizontal direction by
adjusting the rear feet of the cast chassis.
Installation
37