Maintenance - Master POWERLAND ET1501D Bedienungsanleitung

Maintenance

Warning:
Before cleaning the machine, please make sure the power has been switched off.
1. Cleaning: Wipe away the dust on the belt, running board and side footboard as excess dust may increase
the frictional on the belt and cause damage to the machine. It is better to clean the machine once a month.
2. Lubrication:
1) Lubrication is needed per 300km. The machine will sound the alarm "di di di " and displays "OIL" to
inform you to oil. Please lubricate the oil on the middle of the running belt.
2) After lubrication press the STOP key for more than 3 seconds in standby mode and then the machine
will sweep off the alarm and lubrication information.
We suggest you lubricate the machine as the following method:
People who use the treadmill less than 3 hours per week, please lubricate the machine per 6 months
People who use the treadmill less than 3-5 hours per week, please lubricate the machine per 3 months
3. People who use the treadmill more than 5 hours per week, please lubricate the machine per 2 months
4. Running belt is off-center: The Running belt may become off-center after using for a period of time. First
allow the machine to run by it-self and the belt may centralize automatically. If it does not centralize
automatically, you can adjust the position of the belt by screwing the bolt shown in the images below. If the
running belt has shifted to the right, you need to tighten the screw on the right of the belt or loosen the screw
on the left. If the belt has moved to the left, do the opposite.
5. Belt Slipping: Please adjust bolts according to the diagram below. When adjusting the two sides make sure
each adjustment is the same, on either side of the treadmill. We recommend adjusting by half a turn until the
running belt does not slip or deviate. Avoid making the belt too tight as this may damage it.
Attention: In order to prolong the lifespan of the treadmill, we suggest switch off the treadmill for about 10 minutes
after 2 hours' exercising. Running belt is too loose or tight will do harm to the treadmill. So keep a suitable
tightness is very important. We suggest you grasp the running belt and pull it up to a certain distance until you
cannot pull it up anymore. If the distance is between 50-75mm, we think the tightness of the running belt is
suitable.
All manuals and user guides at all-guides.com
EN
25