Connecting The Power Cord - Pioneer AVH-5200BT Installationsanleitung

Connecting the units

Connecting the power cord

Microphone (supplied)
(AVH-5200BT only)
Microphone input Jack (MIC)
(AVH-5200BT only)
4 m
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
2*
4*
Yellow (2*)
Back-up
(or accessory)
Red (4*)
Accessory
(or back-up)
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two. In this case, be sure to connect to both connectors.

Wired remote input (WIRED REMOTE INPUT)
Hard-wired remote control adaptor can be
connected (sold separately).
This product
1*
3*
Fuse (10 A)
Yellow (1*)
Connect to the constant 12 V
supply terminal.
Red (3*)
Connect to terminal controlled by
ignition switch (12 V DC).
17 cm
RGB input
17 cm
Connect leads of the same
color to each other.
Fuse resistor
Fuse resistor
Speaker leads
White: Front left �
White/black: Front left �
Gray: Front right �
Gray/black: Front right �
Green: Rear left � or subwoofer �
Green/black: Rear left � or subwoofer �
Violet: Rear right � or subwoofer �
Violet/black: Rear right � or subwoofer �