Monitor Connection - Conrad 857907 Bedienungsanleitung

- Plug the small white plug of the camera connection line (4), marked with „NTSC", into the socket
„Camera/CAM" at the control unit (1). The plug only fits the socket in the correct polarity. At the end
of the camera connection line, there is a signal line (yellow cinch plug).
- Connect the yellow cinch plug „NTSC" to the yellow cinch socket at the camera (9).
- Connect the black plug of the camera (9) to the connection cable for voltage supply (12)
- Connect the four plugs of the ultrasound sensors (A to D) in the correct order with the sockets „A,B,C
and D" of the control unit (1).
Observe the correct order of the letters at the lines and plug sockets.
- Plug the cable of the warning buzzer (3) into the socket „ALM" of the control unit (1).
Once all plug connections have been made, the voltage supply for the mirror monitor and connection to
the reversing lamp must be made.
The radio parking system consists of two parts that have to be connected to different power sources.
The monitor is connected to the ignition plus.
The ultrasound system, in contrast, must only work if the reverse gear is engaged. It is therefore fed by
the reversing light.
Find out the correct lines by voltmeter measurement or a diode test lamp.
Use an optional cable cutting connector to very easily create a secure contact without separat-
ing the line. For this, place the cable cutting connector around the supply line and the conduc-
tor to be connected into the connector. Press the contact bridge onto the lines with pliers.
Always ensure permanent insulation at the contact point (e.g. insulated crushing connector,
insulation tape, etc.)

Monitor connection

- Connect the red plus line (+) of the monitor connection cable (10) to the ignition plus. This circuit is
secured via a fuse in the fuse box. Additional fuses are not required.
- Connect the black minus line (-) of the monitor connection cable (10) to a ground contact (e.g. car
body).
26