Safety Information - Conrad 857907 Bedienungsanleitung

Safety Information

Please read the entire operating instructions before using the product for the first time;
they contain important information on how to operate the device correctly.
The guarantee/warranty will expire if damage is incurred resulting from non-compliance
with the operating instructions! We do not assume any liability for consequential dam-
age!
We do not assume any liability for property damage and personal injury caused by
improper use or non-compliance with the safety instructions! In such cases, any war-
ranty/guarantee will expire.
To ensure safe operation, the user must observe the safety information and warning notes in these oper-
ating instructions.
The unauthorized conversion and/or modification of the device is inadmissible because of safety and
approval reasons.
The device is only intended as an aid when reversing. It does not relieve the driver from his obligation to
take care. Some obstacles may not or not reliably be recognised due to the manner in which the device
works.
The device only works properly when reversing slowly. When driving faster, the warning may not be in
time.
The device's function may be impaired by strong contamination on the sensors, exhaust development or
rain.
The sensors and camera must not cover the rear lights, the license plate or any other devices of the car
or protrude over the vehicle contour.
During installation and operation, observe the applicable approval provisions and the road traffic ordi-
nance (Straßenverkehrsordnung).
Before any installation, always disconnect the battery minus pole at the vehicle electrics. This prevents a
danger of short circuit. Only connect the negative pole of the battery when you have completely con-
nected the system and checked the connections. In this respect, consider the information of the vehicle
producer to avoid losing vehicle-specific data memory.
You should only use a voltmeter or a diode test lamp for checking the voltage on the on-board cables as
normal test lamps consume excessive currents and can thus damage the electronic system of the car.
20