Disposal; Troubleshooting - Conrad 857907 Bedienungsanleitung

Disposal

Old electronic devices are raw materials and should not be disposed of in the household
waste. At the end of its service life, dispose of the device at the community collection points
according to the applicable statutory regulations. It is prohibited to dispose of the device in the
household waste. You thus fulfil the legal requirements and make your contribution to pro-
tecting the environment!

Troubleshooting

In purchasing the reversing video system, you have acquired a product designed to the current state of
the art and operationally reliable.
Nevertheless, problems or errors may occur.
For this reason, the following is a description of how you can easily remove possible malfunctions your-
self:
Always observe the safety information!
Error
The reverse driving system
does not switch on.
The display shows wrong
distances, and there is a
signal sound although there
is sufficient space.
Repairs other than those described above may only be carried out by an authorised specialist.
Individual defective image points (light or dark pixels) are due to the component and are not
subject to the warranty. This does not reduce or impair system function.
Possible cause
The reverse gear is not engaged. Engage the reverse gear.
No ignition voltage.
The cables are defective.
The fuse is defective.
Programme error
The sensors are very dirty.
Solution
Switch on the ignition.
Check the plug connections (see
connection figure), the fuse in the
„fuse box" at the connection cable
(10) or the flat fuse of the car volt-
age supply.
Take out the reverse gear and put
it in again (reset).
Clean the sensors regularly.
29