What Is Dynamic Route Guidance; Dynamic Route Guidance - JVC KD-NX10 Bedienungsanleitung

Navigation operation
What is dynamic route
guidance?
Dynamic route guidance is used to cal-
culate the route, taking current traffic
announcements into account.
The traffic announcements are transmit-
ted by a TMC radio station in addition to
the radio programme and are received
and analysed by the navigation system.
The reception of traffic announcements
is free of charge.
Note:
As the traffic announcements are trans-
mitted by radio stations, we cannot as-
sume responsibility
completeness or accuracy of the an-
nouncements.
Austria: The location and event code
was made available by ASFINAG and
BMVIT.
134

Dynamic route guidance

In the Route menu, Dynamic Route
Guidance can be started by selecting
START-DYN. R.
If dynamic route guidance has been acti-
vated, a continuous check is made for
the presence of relevant announcements
for the selected route. The route is then
calculated using the "Fastest route" op-
tion, while taking into account current
traffic announcements. If it is deter-
mined during these continuous checks
that a traffic announcement is of rele-
vance for the route guidance, the unit
will automatically re-calculate a new
for the
route to the destination.
NEW ROUTE
There is also the voice announcement
"The route is being recalculated due
to current traffic announcements".
is displayed inversely.
.
is shown on the display.
Note:
If no TMC station can be found, the dis-
play will show
CURRENTLY
RECEPTION IS NOT POSSIBLE
The unit will switch back to the route
guidance display after a short time.
If no TMC stations can be found within
10 minutes, CURRENTLY TMC RE-
CEPTION IS NOT POSSIBLE
appear on the display again and a short
signal tone will sound.
KD-NX10 can receive TMC informa-
tion, whether a TMC station is selected
or not. However, in order to guarantee
optimal reception of TMC information,
we recommend the selection of a TMC
station.
TMC
.
will