Storing A Destination In The Destination Memory - JVC KD-NX10 Bedienungsanleitung

Navigation operation
• RESTRICTIONS
Provides options for avoiding bridges,
ferries, tunnels or toll roads
Make your selection by turning the
right rotary control , and change
any settings by pressing it.
Press the control for more than
2 seconds to accept all settings and
exit the menu.
Note:
Routes without motorways can only
be calculated for short distances (up
to at most 200 km depending on the
density of digitisation).
128
Storing a destination in the
destination memory
It is not mandatory for navigation to
store a destination in the destination
memory. However, it saves repeated
manual entry if the destination is re-
quired again at a later date.
Select SAVE DESTINATION
Route menu and press the right rotary
control to confirm.
A name of your choice consisting of up
to 20 characters can be entered for the
specified destination, and is stored auto-
matically in the destination memory by
pressing the right rotary control
more than 2 seconds. See "Destination
memory" on page 139.
The destination can also be stored by se-
lecting the small tick and briefly
pressing the right rotary control
If you do not wish to enter a name of
your choice, press and hold the right ro-
tary control for more than 2 seconds
to store the previously entered destina-
tion in the destination memory.
The last destination entered can be filed
into any desired position in the Destina-
tion Memory by turning the right rotary
control . The memory position is con-
in the
firmed by briefly pressing the right rota-
ry control .
A total of 50 destinations can be stored.
For final storage in the destination mem-
ory, either start route guidance or switch
the program to a new destination entry
by selecting NEW DESTINATION
for
.
.