Destination Input Via Coordinates - JVC KD-NX10 Bedienungsanleitung

Note:
By pressing the right rotary control
for more than 2 seconds without previ-
ously entering a letter, a list of the pos-
sible location centres will immediately
appear.
Destination input via
coordinates
If the geographical coordinates (latitude
and longitude) of a destination are
known, these can be entered and route
guidance to the destination started.
Select COORDINATES with the right
rotary control and press the control
to confirm.
Enter the latitude of the destination us-
ing the right-hand rotary control
Entries must be made in degrees, min-
utes, seconds and a direction as the
crow flies, e.g. 11°38'34 "N
To confirm the entry, press and hold
the right-hand rotary control
more than 2 seconds.
or
Select the small tick
press the right rotary control
Enter the longitude of the destination
using the right-hand rotary control
as described above.
To confirm the entry, press and hold
the right-hand rotary control
more than 2 seconds.
or
Select the small tick
press the right rotary control
Note:
If the coordinates entered are located
beyond the boundaries of the digital
map, a message will appear notifying
you of this. The system cannot navigate
to a position beyond the boundaries of
.
the digital map.
.
Navigation operation
The navigation system then requests a
for name to be entered for the entered coor-
dinates.
Enter a name as described in "Storing
and briefly a destination in the destination mem-
. ory" on page 128.
The program then switches to the Route
menu.
Route guidance can now start.
for
and briefly
.
125