Troubleshooting Information - Angelo Po 08WFA4G Bedien- Und Installationshandbuch

TROUBLESHOOTING INFORMATION

The appliance has been tested before being put into
service. The information provided below is intended
to assist in the identification and correction of any
anomalies and malfunctions which might occur du-
ring use. The user can solve some of these problems
Fault
Smell of gas.
The pilot light does not ignite.
The pilot light goes out.
The pilot light ignites but the
burner remains off.
IT IT
The flame is yellow.
GB GB
DE DE
Burner control knob is stiff.
FR FR
ES
ES
English
TROUBLESHOOTING
Occasional leak because
The spark ignition devices
Air in pipelines due to long period
The thermocouple has not
Burner dirty, heat exchange pipes
clogged, condensation drips.
Gas control valve malfunction.
himself, but for others specific technical knowledge
or skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
flame has gone out.
are not working.
out of use.
warmed up enough.
- 12 -
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices
are in good working order. Light
by hand with a naked light.
Important
Contact the after-sales ser-
vice
Make more attempts to
light the flame.
Make more attempts to
light the flame.
Check the condition of the
thermostat and activate any
ignition enabling device.
Important
Contact the after-sales ser-
vice
Important
Contact the after-sales ser-
vice
6