Cleaning And Storage; Disposal And Recycling - Scheppach 5909304900 Original Bedienungsanleitung

m WARNING! The fact that the indicator light is
not visible does not guarantee the absence of
voltage. The following factors may affect your
ability to see the indicator light:
• unfavourable lighting conditions, for example, sun-
shine
• temperatures outside the range of –10 °C bis +50
°C
• frequencies outside the range of 50 to 500 Hz
• unfavourable locations such as on wooden ladders,
insulating floor coverings and in non-operationally
grounded AC voltage networks
To test whether alternating current is present,
carry out the following steps:
1. Hold the tip of the voltage tester against a contact
of an electrical cable and
2. touch the other end of the voltage tester with one
finger
If alternating current is present, the lamp will light up.

9. Cleaning and storage

1. Cleaning
Risk of damage!
If the trolley is not cleaned properly it may become
damaged.
• Do not use an aggressive, abrasive cleaning agent
and do not use a solvent, acid or chlorine based
cleaning agent.
• Do not use brushes with metallic or nylon bristles
and do not use sharp or metallic cleaning utensils
such as blades, hard spatulas or similar.
• Use a mild cleaning agent to clean the trolley and a
soft, clean towel. Allow the trolley to dry completely
after cleaning.
• Remove lubricant and oil with a non-flammable
cleaning agent.
Cleaning voltage tester
If the voltage tester is contaminated during normal
use, it can be cleaned with a damp cloth and a house-
hold cleaner. Aggressive cleaning agents must not be
used for cleaning.
2. Storage
m Attention!
Rust could form if the trolley is stored in a damp loca-
tion. The functionality or carrying capacity of the trol-
ley could therefore be permanently and irreparably
impaired.
• Protect the trolley from moisture, direct sunlight
and frost.
• Store the trolley in a dry location.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Keep the trolley away from children
Storage voltage tester
• Do not expose the voltage tester to direct sunlight.
• If the voltage tester is used in accordance with the
operating manual, then no maintenance will be re-
quired.
• If the voltage tester does not function properly,
send it to the service department for repairs.

10. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective com-
ponents must be disposed of as special waste. Ask
your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
GB | 41