Scheppach HC54 Original Anleitungen Seite 59

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Note:
In accordance with valid product liability laws, the manu-
facturer of this device shall not be responsible for damage
to and from this device which results from:
• Improper care.
• Non-compliance with the Operating Instructions.
• Repairs made by unauthorized persons.
• The installation and use of any parts which are not ori-
ginal replacement parts.
• Improper use and application.
• Failure of the electrical system as a result of non-com-
pliance with the legal and applicable electrical directi-
ves and VDE regulations 0100, DIN 57113 / VDE 0113.
We recommend
that you read through the entire operating instructions be-
fore putting the compressor into operation.
m
Read the Operating Instructions::
Carefully read the Operating Instructions before setting
up the compressor or putting it into operation, or before
doing any adjustment or maintenance work.
Dangerous electrical voltage
Attention: Before doing any adjustment, maintenance or
cleaning work on the compressor, switch off the power
supply.
Danger emanating from hot surfaces
Attention: The compressor contains some parts that can
get very hot.
Danger through sudden start
Attention: After failure of electric power, the compressor
can suddenly restart.
Warning:
Before putting the compressor into operation for the
first time, check the oil level and replace the oil plug.
The pressure control has been set in the works for maxi-
mum operating safety. Do not change the given setting.
Before assembly and putting into operation, read the enti-
re Operating Instructions.
These Operating Instructions are to assist you in getting
to know your machine and utilize its proper applications.
The Operating Instructions contain important notes on
how you work with the machine safely, expertly, and eco-
nomically, and how you can avoid hazards, save repair
costs, reduce downtime, and increase the reliability and
service life of the machine.
In addition to the safety requirements contained in the-
se Operating Instructions, you must be careful to observe
your country's applicable regulations.
The Operating Instructions must always be near the machi-
ne. Put them in a plastic folder to protect them from dirt
and humidity. They must be read by every operator before
beginning work and observed conscientiously. Only persons
international 59