Select And Start A Washing Programme - Electrolux ESI 67010 Benutzerinformation

40 electrolux
Activate/deactivate the multitab function
before the start of a washing pro-
gramme.
Once the programme is running, the
multitab function can NO longer be
changed. If you want to cancel the mul-
titab function you have to cancel the pro-
gramme setting and then deactivate the
multitab function. In this case you have
to set a washing programme (and de-
sired options) again.
Activation/deactivation of the Multitab
function
To activate the Multitab function, press the
Multitab button. Corresponding indicator
light comes on.
To deactivate the function press the Multitab
button again. Corresponding indicator light
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Switch on the appliance. It must be in
setting mode.

Select and start a washing programme

Important! Set the options before the start
of a washing programme. When a washing
programme operates, no options can be set.
If it is necessary to set an option, cancel the
washing programme.
Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Press and hold, at the same time, the
function buttons B and C. The pro-
gramme indicator lights above function
buttons A, B and C start flashing
3. Press function button B, the programme
indicator lights above function buttons A
and C go off. The programme indicator
light above function button B continues
to flash. The digital display shows the cur-
rent setting.
Rinse aid dispenser deactivated
Rinse aid dispenser activated
4. To change the setting, press button B
again. The digital display shows the new
setting.
5. To memorize the operation, switch off the
appliance.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the Multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
2. Check that the water tap is opened.
3. Press the on/off button. The appliance
must be in setting mode.
4. Select a washing programme (see
'Washing programmes' chart).
When a programme has been selected
the corresponding light comes on.
Close the appliance door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the flashing number of hours for the delay
start appear in the digital display.