Troubleshooting - IKEA VÄLGJORD Gebrauchsanleitung

ENGLISH

Troubleshooting

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
Problem and alarm code
You cannot activate the ap-
pliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
The salt indicator continues
to stay on after replenish-
ment of the salt container.
Once you have checked the appliance,
deactivate and activate the appliance. If
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the pro-
cedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
.
authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
Clean the filter.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
.
• Close the water tap and contact an Authorised Service
Centre.
.
• If after 3 or 4 programmes, the salt indicator continues to
stay on, contact the service.
This can occur when you are using salt that needs more
time to dissolve.
There in no unwanted effect on the performance of the
appliance.
With some problems, the display shows
an alarm code.
Possible solution
the problem occurs again, contact an
Authorised Service Centre.
21