Troubleshooting Guide - DeWalt XR LI-ION DCN692 Bersetzt Von Den Originalanweisungen

EnGLIsh
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW.
For more serious or persistent problems, contact your nearest authorised D

WARNING: To reduce the risk of serious personal injury, ALWAYS lock off the tool and disconnect battery pack from tool before
all repairs.
sYMPTOM CaUsE
Motor does not run with Trigger lock in locked position
trigger depressed
Tool is stalled, locking the motor from
rotating
Tool is in the sequential actuation mode
Tool internal electronics need to be reset
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot
Motor does not run with Trigger lock in locked position
contact trip depressed
Dry fire lock out engaged, blocking
contact trip from traveling fully
Tool is stalled, locking the motor from
rotating
Bent contact trip
Motor stops running after 5 seconds
Terminals are dirty or damaged
Damaged internal electronics
Damaged trigger
Battery is hot
Tool is hot
Tool does not actuate Dry fire lock out engaged, blocking
(motor runs but will contact trip from traveling fully
not fire)
Low battery charge or damaged battery
Jammed nail/drive blade not returned to
home position
Damaged driver/return assembly
Jammed internal mechanism
Damaged internal electronics
Motor starts up but Jammed nail and driver blade is stuck in
generates a lot of noise down position
Damaged driver/return assembly
50

TROUBLESHOOTING GUIDE

WALT repair agent, or contact your D
e
address indicated in this manual.
FIX
Unlock trigger lock.
Rotate the stall release lever on the tool and the
mechanism will release. If driver blade does not return,
remove battery and manually push driver blade back to
home position.
Depress contact trip first before firing or switch to bump
mode (DCN692 only).
Remove battery, wait 3 seconds and reinsert.
Normal operation, release trigger and redepress.
See authorised D
See authorised D
See authorised D
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Unlock trigger lock.
Load more nails into magazine.
Rotate the stall release lever on the tool and the
mechanism will release. If driver blade does not return,
remove battery and manually push driver blade back to
home position.
See authorised D
Normal operation, release contact trip and redepress.
See authorised D
See authorised D
See authorised D
Let the battery cool or replace it with a cool pack.
Let the tool cool down before continuing use.
Load nails into magazine.
Check charge level if pack shows state-of-charge. Charge
or replace battery pack if necessary.
Remove battery, clear jammed nail, cycle stall release
lever, (push driver blade up manually if necessary) reinsert
battery pack.
Replace driver/return assembly. See authorised D
repair agent.
See authorised D
See authorised D
Use stall release lever, clear any jammed nails, and return
driver blade manually if necessary.
Replace driver/return assembly. See authorised D
repair agent.
WALT office at the
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT repair agent.
e
WALT
e
WALT
e