Package Content - Unify OpenScape CP200 Installations- Und Kurzanleitung

Documentation on Internet
This and other documentation can be found on the Internet at:
http://www.unify.com
mation about firmware updates, frequently asked questions and
lots more can be found on the web at:
http://wiki.unify.com

Package Content

c
a OpenScape Desk Phone CP200/CP205
b Stand
c Handset
d Handset cable
e Installation and Quick Reference Guide
Notes about Place of Use
• Operation of a SIP telephone is only permitted with indoor LAN
cabling. The device shall be connected to the IP infrastructure us-
ing a shielded LAN cable: Cat-5 for 100 Mb/s or Cat-6 for 1000 Mb/
s. The LAN cabling of the building shall ensure that the shield of
this cable is grounded.
• The telephone should be operated in a controlled environment
with an ambient temperature between 5 °C and 40 °C (41 °F and
104 °F).
• Do not install the telephone in a room where large quantities of
dust accumulate; this can considerably reduce the service life of
the telephone.
• Do not expose the telephone to direct sunlight or any other
source of heat, as this is liable to damage the electronic equip-
ment and the plastic casing.
• Do not operate the telephone in damp environments such as
bathrooms.
Connect the Handset to the Telephone
See also overview on page 2.
1. Insert the plug on the long end of the handset cable d into the
jack E
the groove provided.
2. Insert the plug on the short end of the handset cable d into the
jack on the handset c .
 Support.Technical notes, current infor-
a
on the base of the telephone and press the cable into
b
d
e
9