Transportation, Storage And Disposal - Husqvarna Soff-Cut 150 Bedienungsanweisung

Problem
The engine does not start.
The engine does not oper-
ate smoothly or cannot op-
erate at full speed.
Transportation
WARNING: Be careful during transportation.
The product is heavy and can cause injury
or damage if it falls or moves during
transportation.
The wheels let you move the product manually for
shorter distances. For longer distances, lift the product
to move it or put the product on a vehicle.
CAUTION: Do not tow the product behind a
vehicle.
• Attach the product safely during transportation by
vehicle. Attach tie-down straps to the safety frame
and to the vehicle.
• Set the engine ON/OFF switch to the OFF position.
This also closes the fuel valve.
714 - 004 - 06.07.2021
Solution
Do a check if there is fuel in the tank and make sure that it is the correct fuel. Make
sure that there is no water in the fuel.
Make sure that the fuel valve is in the "ON" position.
Make sure that the ON/OFF switch is in the "ON" position.
Make sure that the spark plug cable is connected to the spark plug.
The engine is flooded. Adjust the choke, refer to the operator's manual for the engine.
Make sure that the choke is in the "ON" position for cold starts. Adjust the choke, refer
to the operator's manual for the engine.
Do a check of the oil level. The engine has an oil alert system that stops the engine if
the oil level is too low.
Make sure that the air filter is not dirty or clogged.
Do a check that the blade shaft rotates freely and no concrete has built up in the blade
block.
Do a check if there is fuel in the tank and make sure that it is the correct fuel. Make
sure that there is no water in the fuel.
Do a check of the oil level. The engine has an oil alert system that stops the engine if
the oil level is too low.
Make sure that the air filter is not dirty or clogged.
Make sure that the spark plug is clean and has the correct gap, refer to the operator's
manual for the engine.
Make sure that the throttle control is set correctly.
Make sure that the choke is in the "ON" position for cold starts. Adjust the choke, refer
to the operator's manual for the engine.

Transportation, storage and disposal

• Remove the cutting blade before transportation of
the product.
• Put the product in lower height position.
• For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
• Always use approved containers for transportation of
fuel.
• Fold the product, refer to
25 .
To fold the product
1. Loosen the locking clamp wheel (A).
To fold the product on page
25