Option 2 - Set Number Of Signals - roco Z21 signal DECODER Bedienungsanleitung

Decoder address
1
2
3
4
...
509
510
Example 1: Switch turnout number 1 during the programming process. All signals of the signal decoder are then programmed in
ascending order to turnout numbers starting with 1.
Example 2: Switch turnout number 2 during the programming process. All signals of the signal decoder are also programmed in
ascending order to turnout numbers starting with 1, because turnout number 2 is in the same group of four as turnout number 1 from
the first example.
Example 3: Switch turnout number 10 during the programming process. All signals of the signal decoder are then programmed in
ascending order to turnout numbers starting with 9, see the table above.
The following applies for DCC
the beginning of a group of four. The beginning of the groups of four is calculated automatically when programming the signal decoder.
Each signal occupies 4 turnout numbers. If two signals are used on the signal decoder, then it occupies 2*4=8 consecutive turnout
numbers; if three signals are used, then 3*4=12 turnout numbers, and if four signals are used, 4*4=16 consecutive turnout numbers.
The following applies for DCC
at the beginning of a group of four. The beginning of the groups of four is calculated automatically when programming the signal
decoder. Each signal occupies just one signal address. The signal decoder therefore occupies a maximum of four consecutive DCCext
signal addresses.
The first DCCbasic turnout number and the first DCCext signal address are identical on the Z21 signal decoder.
Factory setting: numbered in ascending order from 1.
6.1.2 Option 2 – Set number of signals
This option is used to program the number of signals which can be connected to the signal decoder.
1. Keep the programming button held down for at least 3 seconds until the white "Program" LED begins to flash. Then release the
programming button. The white "Program" LED will then flash normally once (short, pause; short, pause; etc.), and the green
LED will be lit continuously. The signal decoder is then in "Configuration mode, Option 1".
2. Keep the programming button held down for at least 3 seconds again until the blue "Status" LED and white "Program" LED
begin to flash together. Then release the programming button again. The white "Program" LED will then flash normally twice
(short, short, pause; short, short, pause; etc.). The signal decoder is then in "Configuration mode, Option 2".
3. The current number of signals is then shown through the other LEDs:
1
5
9
13
2033
2037
(see also Switching commands in conventional DCC
basic
(see also Switching commands in the new DCC
ext
Signals (group of four)
2 3
6 7
10 11
14 15
...
2034 2035
2038 2039
format): Each signal is always numbered at
basic
format and Z21): the first signal is always numbered
ext
4
8
12
16
2036
2040
Z21 ist eine Innovation von FLEISCHMANN und ROCO
51