Mechanical Installation; A) Mounitng The Camera Unit - Conrad 841148 Bedienungsanleitung

7. Mechanical Installation

Any changes in the vehicle that become necessary for the installation of the
system or other components must be carried out in such a way that neither traffic
security nor the stability of the car are affected. With many cars, the type approval
will lapse if you merely saw out a section of the sheet metal.
No parts must be installed in the airbag trigger area because this may cause injury
to the vehicle passengers in case of accident.
If there are any doubts regarding selection of the installation site, inquire for
information from your car vendor.
Before drilling the bores, make sure that no electric cables, brake lines, the fuel
tank or similar are damaged.
When using tools to install your system, observe the tool manufacturer's safety
information.
When installing your system, take into consideration the risk of accident which
can arise from devices being torn away in the case of an accident. Therefore, you
should secure every component in a place where it cannot be dangerous to
passengers.
The license plate frame with the camera must not cover the rear lights or any other
devices of the car or protrude over the vehicle contour.
When placing the camera line inside the vehicle, use the serial rubber sleeve in
connection with an elastic sealing mass to avoid impairment of the vehicle
interior's tightness.
a) Mounting the Camera Unit
• Remove your license plate and any license plate frame.
24