Stahl SolConex 8570/11 Betriebsanleitung Seite 29

Installing auxiliary contacts
Open the casing.
Pass the cable through the cable entry into the connection chamber.
Open the screwless clamps, using a screwdriver (2)
(blade 06 x 3.5, shape A, in accordance with DIN 5262 or ISO 2380-1 respectively).
Insert the conductors into the corresponding screwless terminals and clamp them (3).
The stripped ends of the wire must be fully within the terminal clamp.
Align the wires (clamped ends must be relieved of strain).
Tighten the cable entry gland(s).
Close the casing (tightening torque: see Chapter 5, "Technical Data").
8.2 Installation, plug, type 8570/12-...
Screw the cable gland (1) off and remove the dust exclusion plate (2).
Remove the pressure ring (3) and seal (4).
Remove the shell securing screws (5) and remove the plug shell (6).
Insert the cable (max. 4 mm
seal (4). If necessary, cut the seal out to match the cable diameter.
Open the strain relief (7) and swivel it by 90°.
Insert the conductors into the corresponding terminals and clamp them (max. 1.2 Nm).
The stripped ends of the wire must be fully within the terminal clamp.
8570601300
S-BA-8570/11/12-03-en-31/01/2007
2
) through the cable gland (1), pressure ring (3) and
Wall-Mounted Socket, Plug
8570/11, 8570/12
Installation
11202E00
11222E00
11