Carrier 40VC009F-7S-QEE Installations- Und Benutzerhandbuch Seite 15

Installation Procedures
Open the intake grill
(1) Push the embedding switch according to the direction of the arrowhead ( Refer to Figure 2).
(2)Turn the intake grill according to the direction of the arrowhead (Refer to Figure 3).
Figure 3
Remove the side cover
(1) Remove thescrew.
(2) Push the side cover according to the direction of thearrowhead.
(3) Subsequently remove the sidecover.
Cutting the intake grill for drain pipes
1. Remove the air inlet grille and install the drain pipe.
2. Remove the air intake grille before installing the drain pipe and pass the drain pipe through the hole, as shown in the
figure here.
Figure 2
Side cover
screw
Location of the cut
8
After removal