WimTec OCEAN S7 Montage- Und Bediensungsanleitung Seite 32

EN
OCEAN S7
Assembly
7
10
!
ATTENTION!
Perform the following steps
in the order indicated!
32 Shower control
All manuals and user guides at all-guides.com
8
16
7.
Feed the 2 x 0.5 mm
flush-mount set and connect it to the power supply (art. no.
117 899 and art. no. 113 792). Attention: The power supply
must not be installed in the flush-mount set!
8. Connect the magnetic valves to the electronics module.
(yellow = hand shower, no marking = head shower,
red = therm. disinfection)
9. Connect the power cables to the electronics module
(watch for correct polarity +/-) and connect the grounding
wire to the water path.
10. Where necessary, Feed the control line for thermal
disinfection (2 x 0.5 mm
module (see page 35).
11. Configure the desired functions at the electronics module
(see page 29).
12. Insert the electronics module into the flush-mounted set.
WimTec OCEAN S7
9
11
2 power connection cable and into the
) and connect it to the electronics
2