Siemens SINUMERIK Bedienhandbuch Seite 72

Anhang
A.2 Beispiel für Capture Konfiguration
Programmcode
"unit": "deg"
},
"6",
"axistype": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#RotaryAxis",
"channelid": "1",
"dataclass": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#CommandedPosition",
"unit": "deg"
},
{
"address": "DES_POS|8",
"axisid": "8",
"axisname": "C1",
"axistype": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#MasterSpindle",
"channelid": "1",
"dataclass": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#CommandedPosition",
"unit": "deg"
},
{
"address": "DES_POS|9",
"axisid": "9",
"axisname": "CM",
"axistype": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#RotaryAxis",
"channelid": "1",
"dataclass": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#CommandedPosition",
"unit": "deg"
},
{
"address": "DES_POS|12",
"axisid": "12",
"axisname": "YM",
"axistype": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#LinearAxis",
"channelid": "1",
"dataclass": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#CommandedPosition",
"unit": "mm"
},
{
"address": "DES_POS|19",
"axisid": "19",
"axisname": "Z2",
"axistype": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#LinearAxis",
"channelid": "1",
"dataclass": "http://www.siemens.com/sinumerikedge/
machine_tool_upper_layer.owl#CommandedPosition",
"unit": "mm"
}
],
72
{
"axisname": "C",
"address": "DES_POS|6",
Bedienhandbuch, 10/2019, A5E49004592A AA
"axisid":
Analyze MyWorkpiece /Capture