Chapter 3 Product Information; Unit Overview; Functional Description - Helios KWL 170 W/W ET Montage- Und Betriebsvorschrift

Installation and Operating Instructions
EN
CHAPTER 3
PRODUCT
INFORMATION
Central ventilation unit – KWL 170 W/W ET
3.1

Unit overview




15
 15
16

 3
8

Supply air fan

Extract air fan

Filter covers Suppl. and extr. air

Panel

Unit door

Back panel

3.2

Functional description

The unit has a heat exchanger. The heat exchanger continuously extracts heat from the stale room air (extract air) and
transfers this heat to the fresh intake air, which flows into all rooms connected to the duct system as pre-heated, filtered
supply air. The stale air is extracted from the connected rooms via the duct system. It flows through the duct system
back to the ventilation unit, gives off heat and is led outside through the exhaust air duct (see Fig. 2).
The heat recovery efficiency depends on the factors of humidity and the temperature difference between intake and
extract air. Units with enthalpy heat exchangers (KWL 170 W ET) recover humidity from the extract air in addition
to heat, which is returned to the rooms through the supply air.

4
5
9

9

7

12
 1
 2
Bypass motor

Heat exchanger

Design panel

Ball siphon

Cover plate Supply air

Terminal box

7

13
 11
10

Cable gland

Wall bracket

Filter Extract air Coarse 65 %

F ilter Supply air Coarse 65 %
Filter Supply air ePM1 50 %

Fig. 1

14

6