CombiSteel 7464.0035 Gebrauchsanweisung Seite 8

Removing the pallet
Your cabinet has been fixed with 4 units of cable connectors on wooden pallet before shipping. Please follow the
instructions below before placing on its place.
Detach and remove cable connectors fixing cabinet and wooden pallet in front and back sections through a cutter
device. Lean the cabinet slowly backwards from front and turn aside, and make sure adjustable legs are released
from housings. Lean cabinet backwards from backside and remove pallet from underneath cabinet. Observe
floor of cabinet and if not smooth, put product on scales.
Levelling the cooler

Never remove the door blockings before the cooler is placed in its final position.

For the sliding doors function properly, the floor surface must be smooth and the body must be levelled.

For levelling: when the cooler is slightly lifted up on the forklift, loosen the leveler bolts so as to reach
the desired level of height above the floor. Gently place down the cooler on the floor and check for
levelling with a spirit le....f the cooler tilts, readjust the leveler bolts. Upon perfect levelling, set the
cooler in its final operating position and remove the door blockings. Your double door cooler is now
ready to operate.
Mounting the shelves
There are 4 shelves and 16 shelf supports shipped inside the cooler. Carry out the following to mount the shelves.

Pilasters are numbered to provide height adjustment between the shelves in line with the product
requirements. Place the shelf supports into corresponding notches on the pilasters. For an easy
placement, use a pair of pincers to grip the support ends.

Lay down the four shelves on the cooler floor. (Make sure that the right-angled (90°) side is at the rear).

Hold the uppermost shelf; tilt one side and place on the hooks on the corresponding supports.

Do the same for the remaining shelves and mount them all.
Dismantling the illuminated advertisement panel
If it ever requires dismantling the illuminated advertisement panel, do the following:
The LEFT lid is screwed to the body and it is not possible to dismantle it from the
outside.
Therefore do not try to remove it. Advertisement panel is fixed to the RIGHT lid. Hold
the right lid on the top and bottom sides and pull it RIGHTWARDS. The right lid will slide
on the upper and lower tracks allowing the compartment to open. Once the
compartment is open, carry out the needed (replacing the florescent lamps) and close
the compartment by pulling the lid in the opposite direction.
Replacing the fluorescent lighting: (if your product has fluorescent lamp)
Before dismantling the lamp, always unplug your cooler. After dismantling the lamp cover inside the cooler,
remove the lamp and always replace it with a lamp of the same features (length, power, etc.)
www.combisteel.com
8