Troubleshooting - CombiSteel 7464.0035 Gebrauchsanweisung

Your cooler has been designed not to make any frost. However if it is operated in a very damp environment or if
its door/lid is frequently opened, some frost may occur. For manual defrosting:
Adjust the thermostat to zero and unplug the cooler. Remove the stuff from the cooler and keep them
somewhere cold or wrap them with an insulating material. Open the door/lid of your cooler and allow for
defrosting. Never use any scraper or sharp tools to remove frost or ice.
Attention: never use any hot water, electrical heater, sharp tools or similar things as they may ham the cooler.
Holidays/stop using for a while:
Do not unplug your cooler if you are going on a holiday or stop using it for a short time. If you are going on a
holiday or stop using the body for a long time, unplug the cooler and empty it. After defrosting, clean the cooler
and wipe it out with a cloth. Leave the doors open to prevent odour in the cooler.
Transporting your cooler:
Before relocating the body, unplug it from the mains socket, defrost it, wipe the interior walls and floor with a
damp cloth, place the plastic blockings between the glass door and the body and carry it in the normal position
as it is used.
Attention: expansion gas (C-Pentane) is used in the insulation system of the cooler. When you dispose the body,
it requires observing the applicable laws and rules of the country in which it is used. Cleaning / maintaining of
your cooler's condenser must be done at least two times in a year by authorized service.

7. TROUBLESHOOTING

If the cooler does not function:

Check if the cooler is properly plugged in the mains socket.

Check if there is electric current to the mains socket.

Check if the fuse has blown out or if there is power failure.
If the cooler operates more frequently than desired:

Check if the door is opened very frequently or left open for a long time.

Check if the thermostat is set to chill more than desired.

Check if the compressor compartment is blocked with dust, properly ventilated or it needs cleaning.
If the cooler does not cool enough:

Check the temperature setting.

Check if the door is opened very frequently or left open for a long time.

Check if the internal air circulation is interrupted by overloading.

Cleaning/maintaining of condenser might not be done (please see Section 6).
If there is odour in the cooler:

Check if odorous stuff is openly stored.

Check if inside is properly cleaned.
After having checked the above mentioned points and carried out the recommendations, if your cooler still
functions unsatisfactorily, contact the nearest authorized service centre, informing your complaints as well as
the model and serial number of your cooler.
www.combisteel.com
10