Assembly; Operation - CombiSteel 7464.0035 Gebrauchsanweisung

Class
0
1
2
3
4
5
6
7
8

4. ASSEMBLY

Air circulation at the rear is required for the body to operate efficiently. Move the cooler backwards to place it
properly. Allow minimum 10cm of space from the sides and the rear in order to ensure proper air circulation.
Clean your cooler before operating it (see Cleaning). Your cooler is now ready to plug in.

5. OPERATION

Clean your cooler before operating it (see Cleaning). Since the location, ambient temperature and door-open
time and frequency are the factors affecting the interior temperature of the cooler, thermostat setting must be
done accordingly. Avoid blocking air circulation inside the cooler, when loading the cooler with products.
Otherwise undesired and extensive temperature variances may occur between the top and bottom
compartments of the cooler. Control panel is located interior and consists of the following components:
Thermostat setting knob (optional):
It is used to regulate the internal temperature of your cooler.
Thermostat adjustment is the most optimum adjustment in products with mechanical thermostat in factory
defaults. It is recommended not to be replaced as long as it is not troubled with the inter product temperature.
If you think that the product is not in desired temperature range you can make thermostat adjustment.
Thermostat setting must be done according to the features of the products to be preserved. Temperature setting
can be done by means of turning the black thermostat knob on the control panel by the help of a coin or similar
object. Turning the knob right decreases the internal temperature, whereas turning it left increases the internal
temperature. Turning the knob leftmost stops the compressor, which in turn stops the chilling process, although
the electric current to the cooler is not cut off.
Lighting switch: It is used to turn on or off the both fluorescent lamps inside the body.
Installation and removal of slide-doors:
Carry out the following steps whenever slide-doors require installation and removal:
Climate Classes
Temperature °C
20
16
22
25
30
27
40
35
23,9
www.combisteel.com
Relative humidity %
50
80
65
60
55
70
40
75
55
Dew point °C
9,3
12,6
15,2
16,7
20
21,1
23,9
30
14,3
6