Introduction; Precautions And Safety Instructions Before The Initial Start-Up - CombiSteel 7464.0035 Gebrauchsanweisung

1. INTRODUCTION

This operating manual has been designed to facilitate the use of your double door cooler with maximum
efficiency over the years. In all of the manufacturing processes "environmentally-friendly" technologies are used
as well as materials and refrigerants that are not harmful to the nature. Please read this manual carefully before
you start operating your cooler in order to ensure maximum efficiency from this product that has been
manufactured to serve you over the years.
As an initial step, please carefully read this manual thoroughly in order to ensure maximum efficiency from
your cooler and prevent user defects.
Detect the cooler immediately on delivery for any damage. In case of any damage, contact with your authorized
dealer within 24 hours.
Attention: it requires a lapse of minimum 2 hours after any transportation before you start operating your cooler.
If the cooler has remained in an environment, the temperature of which was below 0°C for a long period, allow
for the compressor temperature to reach beyond +5°C before re-operating the cooler.

2. PRECAUTIONS AND SAFETY INSTRUCTIONS BEFORE THE INITIAL START-UP

Reinsert the conical door blockings, removed while unpacking your cooler and transfer the body to its final
operating location. Unscrew the head screws fastened at four corners to the base in order to detach the wooden
pallet from the body. When the cooler is moved to its final operating position, remove the door blockings.
For the slide-doors function properly, the body must be sufficiently levelled. Therefore, once the cooler is set in
its final operating position, before loading, remove the front panel and the rear grille and level the body with the
leveller bolts screwed to the base to ensure that the cooler is exactly parallel to the floor.
Use a level spirit fora prompt result.
If the cooler inclines right, left, front or backwards, this might cause problems for the sliding doors in counter
balancing or getting caught. Problems in counter balance and incomplete closing of slide-doors is an undesired
situation for it causes extra energy consumption. The nominal voltage and frequency requirements for the body
are specified on the data plate.
Do not relocate the cooler or move the cooler on its rollers while its loaded with product. If cooler is empty,
please do not push the cooler to pass over cables or door frames, to avoid roller damages. Never push the
cooler when the pavement is uneven, having inclination, or there are stairs nearby.
Do not use multi socket and extension cable.
The main power supply to which the cooler is connected must have a leakage current relay.
Call the authorized service centers for replacement, in case the supply cord /plug is damaged. Your cooler must
be plugged certainly in an earthed wall socket.
Never make any repairs or carry out maintenance while the cooler is plugged in the mains socket.
If the fluorescent lamps don't light or start to blinking, please call technical service to fix it in a short while.
Please do not remain your cooler with non-working lighting system more than few days.
Do not position the cooler in a place, close to a source of strong heat or exposed to direct sunlight. Always
remember that the UV lights in the sunlight deteriorates beverages in the glass door coolers.
Unless otherwise stated, do not place your cooler to open areas where water can leak in.
Do not wash with pressurized water or hose when cleaning the product and its surroundings, use a wet cloth.
Otherwise, the water which may intrude into the electrical components of the product can cause electric shock
and fire risk.
3
www.combisteel.com