CombiSteel 7464.0035 Gebrauchsanweisung Seite 7

Start with dismantling the right door. It is not possible to dismantle the left door before the right one is removed.
There are two slots on the rear of the upper door tracks, each at an approximately 30cm distance from the body
sides. You can carefully determine the exact location with your hand in the door track. Position the door rollers
under the slots. Hold the door on both sides and lift up in the track. Rollers will fit into the slots, allowing the
door to elevate enough to get released off the lower track. (If the rollers are not perfectly positioned under the
slots, the door cannot be lifted up, making it impossible to dismantle. In such a case, do not force to lift up the
door as the upper and lower tracks can get damaged). While elevated, release the door off the lower track and
slightly tilt out to dismantle and gently place down on the floor. Pay attention that the door return-spring is still
attached on the door bracket.
If you want to detach the door, take out the spring end of the bracket hole and allow the spring gently return to
the upper track. Do not release the spring at once, as it might cause injuries.
In order to reinstall the slide-doors, the door return spring must be reattached to the door bracket. Twist the free
end of the spring 5-6 rotations in the opposite direction and insert in the bracket hole. When the spring end is
twisted back 5-6 rotations, door return spring will gain proper tension, allowing for the reinstallation of the door.
Install the left door in between the upper rear aluminium track and lower rear track on the bottom plastic frame.
Then install the right door in the front tracks. When you release the door, it closes fast with the tension on the
spring. (Important: When you want the change the location of your cooler, insert wooden door blockings
between the doors and the plastic tracks underneath before transporting. Otherwise doors can get damaged
upon getting off the tracks).
Hold-open mechanism
Hold-open mechanism allows easy loading and unloading. When it requires holding the doors open, pull the right
door leftmost. As it approaches the left side of the cooler, it will fit into the gap between the aluminium thread
and stopper on the door track and stay motionless. (In order to hold the left door open, pull it rightmost). Since
the door won't close because of the spring tension, you can easily carry out loading and unloading.
In order to close the door, pull in the closing direction. The door will come off the gap and return to its regular
functioning. (Only for S 880/900/1000/1200 SC DD models)
Attention: if your cooler is not sufficiently levelled, you may not operate this hold-open mechanism satisfactorily.
Adjusting the slide-doors
Adjust the doors as follows if they are not properly aligned and if any gap remains at the sides when they are
closed due to inclined floor surface or any other reason.
Remove the door as described above (do not release the spring off its bracket). Door adjustment washer is
located between the roller and the nut. Therefore, grip the roller nut with an appropriate wrench and loosen the
roller by the help of a flat screwdriver inserted in the slot on the front side. Adjust the door by inserting the
adjustment washer into an upper or lower notch on the bracket. When you close the door, if there is a gap at the
bottom, insert the right bracket washer into un upper notch, whereas insert the left bracket washer into an upper
notch, if there is a gap at the top. If both washers are already fixed in the uppermost notches, do the adjustment
by inserting one of the bracket washers into a lower notch.
Following each adjustment, reinstall the door as described above and check for the proper door alignment. If the
door rubs against the bottom track due to misplaced washers, insert the adjustment washers of both rollers into
the lowest notches and redo the adjustment.
7
www.combisteel.com