energy, the negative pressure of the room
must not exceed 4 Pa (4 x 10-5 bar).
Installation
Both
electric
installation must be carried out by
specialised personnel. ● The electrical
appliance is designed to be built into a
work top with a thickness of 2-6 cm in the
case of TOP installation; 2.5-6 cm in the
case of FLUSH installation. ● The
minimum distance between the hob and
the wall must be at least 5 cm in front, at
least 4 cm on the sides and at least 50 cm
from overhead wall units. ● NB = The
recommended distances are given as
examples: when planning the spaces,
the
indications
manufacturer must be observed.
This product is a class 3 recessed
appliance.
Electrical connection
-The installation must be performed by
professionally qualified personnel familiar
with the applicable installation and safety
standards ● The manufacturer declines all
responsibility to persons, animals or
property if the guidelines provided in this
handbook are not followed. ● The power
cable must be long enough to allow
removal of the hob from the worktop ●
Make sure that the voltage on the rating
plate on the bottom of the device
corresponds to that of the house where it
will be installed. ● Do not use extension
cords. ● Earthing is required by law ● The
earth power cable must be 2cm longer
than the other cables ● At no point along
the length of the cable must it reach a
and
mechanical
of
the
kitchen
temperature of 50° C above the room
temperature. ● The device is intended to
be permanently connected to the electrical
network, therefore, make the connection
to the fixed network via a standard
omnipolar switch, which assures the
complete disconnection of the mains
under category III over-voltage conditions,
and which is readily accessible after the
installation.
● Please note! Before reconnecting the
circuit to the mains power supply, make
sure that it is working correctly, always
check that the power cable is correctly
installed.
●
interconnection cable must be replaced by
the authorised technical support service or
by a person with similar qualifications.
Caution! Failure to install screws and
fasteners in accordance with these
instructions may result in electrical
hazards.
Gas connection
● The installation must be performed by
professionally qualified personnel familiar
with the applicable installation and safety
regulations. ● Connect the device to the
cylinder or gas supply in accordance with
the provisions of the standards in force,
making sure in advance that the
equipment is pre-configured for the type of
gas available.
● If not, refer to: "Adaptation to different
types of gas". ● Check also that the
supply pressure falls within the values in
the table: "Characteristics of gas
11
Please
note!
The