Refilling Water Tank - Sharp KV-840E Bedienungsanleitung

REFILLING THE WATER TANK
The unit can be used in the Clean Air Mode without
putting water in the Water Tank. When using the Clean
Air & Humidify Mode, or the CLEAN ION SHOWER
Mode, the Water Tank should be filled with water.
1
Remove the Water Tank by unlatching the
top.
2
Remove the Water Tank Cap and carefully
fill the Water Tank with tap water.
• Change the water in the Water Tank every day with
fresh tap water.
3
After filling, securely tighten the Tank Cap.
• Check to see that there is no water leaking.
• Be sure to wipe off any excess water on the outside of
the Water Tank.
• When carrying the Water Tank, hold it with both hands
so that the Water Tank opening is facing up.
4
Replace the Water Tank in the unit.
• The top latch will "click" in place when the Water Tank
is properly installed.
CAUTION
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water (40 ºC), chemical agents, aromatic substances, dirty water, or other
damaging substances, deformation and/or malfunction may occur.
• Use only fresh tap water. Use of other water sources may promote the growth of mold, fun-
gus and/or bacteria.
KC-840E_Eng2.indd 7
Tank Cap
E-7
Tank Handle
Water Tank
Humidifying
Tray
Water Tank
tighten
08.10.10 9:23:26 AM