Electrical Installation; Connection Terminals - Nicotra Gebhardt EKE05-00 Serie Bedienungsanleitung

2.3 Electrical Installation

Warnings

The inverter must always be grounded. If the inverter is not grounded
correctly, extremely dangerous conditions may arise within the inverter,
which could prove potentially fatal.

To ensure the safe operation of the equipment, it must be installed and
commissioned by qualified personnel in full compliance with the
warnings laid down in these operating instructions.

Take particular note of the general and regional installation and safety
regulations regarding work on dangerous voltage installations (e.g.
EN50178), as well as the relevant regulations regarding the correct use
of tools and personal protective equipment (PPE).

The mains input and motor terminals can carry dangerous voltages even
if the inverter is inoperative; wait 10 minutes to allow the unit to
discharge after switching off before carrying out any installation work.

2.3.1 Connection Terminals

Figure 2: Front panel terminals of type EKE05-00xx-5E-IL (L
Figure 3: Front panel terminals of type EKE05-00xx-5E-IM/-IG (Modbus and GBUS interface)
Installation
®
W interface)
ON ORKS
EN-11 of 38