Mechanical Installation - Nicotra Gebhardt EKE05-00 Serie Bedienungsanleitung

2.2 Mechanical Installation

Warnings
 The inverter must always be grounded. If the inverter is not grounded
correctly, extremely dangerous conditions may arise within the inverter,
which could prove potentially fatal.
 To ensure the safe operation of the equipment, it must be installed and
commissioned by qualified personnel in full compliance with the warnings
laid down in these operating instructions.
 Take particular note of the general and regional installation and safety
regulations regarding work on dangerous voltage installations (e.g.
EN50178), as well as the relevant regulations regarding the correct use of
tools and personal protective equipment (PPE).
 The mains input and motor terminals can carry dangerous voltages even if
the inverter is inoperative; wait 10 minutes to allow the unit to discharge
after switching off before carrying out any installation work.
all dimensions in mm (in)
EKE 05-0018
EKE 05-0040
Installation
Figure 1: Drill pattern
A B
142 (5.59) 144 (5.669)
187 (7.362) 189 (7.441)
C
71 (2.795)
93.5 (3.681)
EN-10 of 38