Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 Installation
Warnings
Work on the device/system by unqualified personnel or failure to comply with
warnings can result in severe personal injury or serious damage to material.
Only suitably qualified personnel trained in the set-up, installation,
commissioning and operation of the product should carry out work on the
device/system.
This equipment must be grounded.
The following terminals can carry dangerous voltages even if the EC-
Controller is inoperative:
2.1 Ambient Operating Conditions
Humidity Range
90% Non-condensing
Altitude
If the inverter is to be installed at an altitude > 1000m, derating will be required.
Shock
Do not drop the inverter or expose to sudden shock.
Vibration
Do not install the inverter in an area where it is likely to be exposed to constant vibration.
Electromagnetic Radiation
Do not install the inverter near sources of electromagnetic radiation.
Atmospheric Pollution
Do not install the inverter in an environment, which contains atmospheric pollutants such as
dust, corrosive gases, etc.
Water
Take care to site the inverter away from potential water hazards, e.g. do not install the
inverter beneath pipes that are subject to condensation. Avoid installing the inverter where
excessive humidity and condensation may occur.
Installation and overheating
Warning
Do not cover the inverter casing.
Installation
the power supply terminals L1, N
the motor terminals U, V, W
rotor position sensor terminals
EN-9 of 38
Werbung
Kapitel
Inhaltsverzeichnis
