Specifications - Makita PV7000C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Speed adjusting dial
3-1. High-Low speed setting button
4-1. Cover
4-2. Side grip
5-1. Cover

SPECIFICATIONS

Max capacities
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and paint.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
Explanation of general view
5-2. Side grip
6-1. Backing pad
6-2. Spindle
6-3. Wrench
7-1. Sponge pad
7-2. Pad
8-1. Wool bonnet
Model
Sponge pad / Wool bonnet
Spindle thread
)
0
Overall length
Net weight
Safety class
noise level determined
) : 81 dB (A)
pA
) : 92 dB (A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h,P
2
ENE051-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENF002-2
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG905-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Electronic Polisher
ENG900-1
Model No./ Type: PV7000C
sum)
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
ENG901-1
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
3
8-2. Lock nut
8-3. Rubber pad
9-1. Lock nut wrench
9-2. Wrench
13-1. Limit mark
14-1. Brush holder cap
14-2. Screwdriver
PV7000C
180 mm
M14
-1
2,100 min
210 mm
2.1 kg
/II
ENH101-18