Specifications - Makita 9237CB Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Lock button
2-2. Switch trigger
3-1. Speed adjusting dial
4-1. Head cover
4-2. Screw
4-3. Screwdriver
5-1. Protrusion of loop handle
5-2. Matching hole in gear housing
6-1. Loop handle
6-2. Hex wrench

SPECIFICATIONS

Max. capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for polishing.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Vibration
The vibration
determined according to EN60745:
Work mode : polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Downloaded from www.Manualslib.com
6-3. Bolt
7-1. Loop handle
7-2. Hex wrench
7-3. Bolt
8-1. Wool pad
8-2. Sleeve 18
8-3. Backing pad
8-4. Spindle
8-5. Shaft lock
9-1. Wool bonnet
9-2. Lock nut
Model
Wool pad
Wool bonnet
Spindle thread
Rated speed (n) / No load speed (n
Overall length
Net weight
Safety class
A-weighted noise level
) : 83 dB (A)
pA
) : 94 dB (A)
WA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h,P
2
manuals search engine
Explanation of general view
)
0
ENE087-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-2
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
ENG905-1
vibration emission value may be different.
determined
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENG900-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
vector sum)
is running idle in addition to the trigger time).
4
9-3. Rubber pad
9-4. Spindle
9-5. Shaft lock
10-1. Lock nut wrench
10-2. Shaft lock
14-1. Screw
14-2. Dust cover
15-1. Limit mark
16-1. Screwdriver
16-2. Brush holder cap
9237CB
180 mm
180 mm
M14 or 5/8" (country specific)
-1
3,200 min
431 mm
3.4 kg
/II
ENG902-1