Specifications - Makita GD0800C Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Slide switch
2-1. Speed adjusting dial

SPECIFICATIONS

• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Model GD0800C
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Model GD0810C
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model GD0800C
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Downloaded from www.Manualslib.com
3-1. Side handle
4-1. Wrench 19
Model
Collet size
Max. wheel point diameter
Rated speed (n) / No load speed (n
Overall length
Net weight
Safety class
) : 78 dB(A)
pA
) : 79 dB(A)
pA
Wear ear protection
2
) : 2.5 m/s
h,AG
2
manuals search engine
Explanation of general view
GD0800C
8 mm max.
25 mm
) 7,000 - 28,000 (min
0
371 mm
1.7 kg
ENE050-1
If the tool is used for other applications, the vibration
values may be different.
Model GD0810C
ENF002-2
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG900-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
4-2. Wrench 13
4-3. Collet nut
GD0810C
8 mm max.
50 mm
-1
) 1,800 - 7,000 (min
371 mm
1.7 kg
/II
2
) : 2.5 m/s or less
h,SG
2
-1
)
ENG902-1