Treatment Session; After Your Treatment Session - TensCare perfect mama+ Bedienungsanleitung

Alternative pad placements
caesarean
The electrodes can be placed in a
crossed pattern with close proximity to
suture site over the incision, two being
above and two below the incision.

11.4. TREATMENT SESSION

1) Press and hold the ON button on the
control unit for 3 to 5 seconds to
switch the control unit on.
The LCD display will appear as A 00
indicating that the unit has set itself
into Labour Pain Phase A and Mode
Burst at Zero intensity (00 mA).
2) You can now adjust the intensity of
the stimulation with the buttons ▲
and ▼ until you reach a comfortable
level. The LCD display shows the
strength of intensity used for each
channel.
3) Just remember
programmes A, B and C which you
can choose at any time as your
labour progresses, and when you
need a boost, just press the BOOST
button (see section 7).
for
11.5. AFTER YOUR
After use, press and hold the OFF
button on the control unit for 3 to 5
seconds to switch the control unit off
1) Once the unit off, remove the
2) Replace the electrode pads to their
Before the birth, you can use your
Perfect mama+ to help with back pain,
and after with post birth pain.
Perfect
stimulation can be used with the breast
electrode pads* (see E-CMR60130) to
help initiate lactation. However, it is not
intended to treat any medical issues
and
appropriate therapy should be to
consult
the three
advisor.
Storage:
If you plan to put your Perfect mama+
into storage for your next baby then do
the following:
• Remove batteries
21
Note: If the sensation becomes
uncomfortable,
intensity.
TREATMENT SESSION
electrode pads from your skin by
holding the pad itself and gently
pulling.
protective plastic shield and return
them to the re-sealable plastic bag.
Note: When
electrode pads, DO NOT PULL
ON LEAD WIRES.
mama+
programme
your first step
your professional
reduce the
removing the
A1
in deciding
medical