11.16 Gerätestatus-Codes - Endress+Hauser Tankvision Tank Scanner NXA820 Handbuch

Tankvision NXA820, NXA821, NXA822
11.16 Gerätestatus-Codes
Die Gerätestatus-Codes sind nur für Service-Arbeiten gedacht. Sie sollten nicht für
Standardvorgänge verwendet werden.
Diagnose Kurztext
Code
F101 NXA 820 Conn. Lost Unable to Communicate with NXA820
F301 Data Mem. Fault
F302 LAN Fault
F303 SYNC Fault
F304 FPGA Error
F305 NV Data Error
F306 Order Code Error
F308 Watchdog Error
F309 FS Security Err
F310 High CPU Load
F311 Low Disk Space
F312 Low RAM
F313 Bad Thread
F314 Reset by WD
F315 CheckSum Error
F316 Language Error
F317 Access Cnfg Err
F318 FPGA Config Err
F319 RTC LowVolt Err
F320 Time Read Err
F321 Time maybe bad!
F322 RTC Nvmgr Err
F501 Database Fault
F502 Not Configured
C503 HART Tunneling
F504 Subscrip. Store
M505 Time Server
C506 Field Scan Off
C507 Interface Off
C508 SYSTOOL Error
Grund
Failed to Detect or Initialize Data Flash Memory
LAN Cable Disconnected or Failed
SYNC Link Cable Disconnected or Failed
Unable to access FPGA
The data in the NV memory does not match the
RAM copy
The factory set order code is invalid, NXA is
unable to startup
Software Watchdog Error
Security policy compromised due to file-system
error
High CPU Utilization
Low Disk Space
Low RAM
Bad Thread Status
Hardware reset by WatchDog
CheckSum Error
Language Installation Error
Access Configuration Error: No machines regis-
tered for access
fpga.conf file is corrupted or not available
Real Time Clock Battery Low voltage Detected
Real Time Clock Read Error
Time maintained by the RTC might be wrong
RTC could not access NV memory to store or
retrive time
Database Failure
LAN Has Not Been Configured
Gauge Configuration In Progress
Subscription Store Cannot Be Found
The fieldscan has been stopped
The hostlink interface has been stopped
SYSTOOL execution error
Menü "System"
Mögliche Lösung
To reprogram with proper SREC
The battery might have drained if
the kit was off for a long duration
Check if i2cdriver started and
working fine
Confirm and set the time on the
kit
Check if nvmanager started and
working fine
183