16.15 Gerätestatus-Codes - Endress+Hauser Tankvision Tank Scanner NXA820 Handbuch

Menü "Systemadministration"
218
16.15 Gerätestatus-Codes
Dier Gerätestatus-Codes sind nur für Servicearbeiten gedacht. Sie sollten nicht für Standard-
vorgänge verwendet werden.
Diagnose-Code Kurztext
F101 NXA 820 Conn.
Lost
F301 Data Mem. Fault
F302 LAN Fault
F303 SYNC Fault
F304 FPGA Error
F305 NV Data Error
F306 Order Code Error
F307 Expansion Board
Fault
F308 Watchdog Error
F309 FS Security Error
F310 High CPU Load
F311 Low Disk Space
F312 Low RAM
F313 Bad Thread
F314 Reset by WD
F315 CheckSum Error
F316 Language Error
F317 Access Cnfg Err
F318 FPGA Config Err
F319 RTC LowVolt Err
F320 Time Read Err
F321 Time maybe bad!
F322 RTC Nvmgr Err
C324 Archive Export
Started
F325 NAND not
accessible
F326 NAND Write
exceeded
F327 NAND Write stop
exceeded
F328 Database corrupted Configuration database corrupted
Ursache
Unable to Communicate with NXA820
Failed to Detect or Initialize Data Flash
Memory
LAN Cable Disconnected or Failed
SYNC Link Cable Disconnected or Failed
Unable to access FPGA
The data in the NV memory does not match
the RAM copy
The factory set order code is invalid, NXA is
unable to startup
Expansion board type does not match
expected protocol type or failed to program
FPGA
Software Watchdog Error
Security policy compromised due to file-
system error
High CPU Utilization
Low Disk Space
Low RAM
Bad Thread Status
Hardware reset by WatchDog
CheckSum Error
Language Installation Error
Access Configuration Error: No machines
registered for access
fpga.conf file is corrupted or not available
Real Time Clock Battery Low voltage
Detected
Real Time Clock Read Error
Time maintained by the RTC might be
wrong
RTC could not access NV memory to store or
retrive time
–
NAND Flash damaged
NAND Flash Write operation exceeded
NAND Flash Write operation stop exceeded –
Tankvision
Mögliche Lösung
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
To reprogram with proper
SREC
The battery might have
drained if the kit was off
for a long duration
Check if i2cdriver started
and working fine
Confirm and set the time
on the kit
Check if nvmanager
started and working fine
–
–
–
–
Endress+Hauser