Installation Procedures; Before Installation - Carrier 40VU007-7G-QEE Installations- Und Bedienungsanleitung

Installation Procedures

Before installation

Make correct operation according to the manual when installation.
Please confirm the below information:
• If operation plan has been discussed;
• Model, power supply specs;
• Pipe, wire, and the other parts;
• Accessories (inside the unit, take it out after opening the filter)
Heat insulation for nut on flared section
1 Pipe cover
2 Pipe cover
3 Strap
For unit suspension
1 Flat washer (M10)
2 Paper pattern
3 Bolt
For drainage pipe
1 Pipe cover
2 Drainage pipe
3 Flexible hose clip
Selection of installation location for the indoor unit
Indoor units should be installed in places with the environment of even circulation of cool and
warm blowsThe following places should be avoided.
• Places with high salinity (beach), high sulfureted gas (such as the thermal spring regions where
copper tubes and soft soldering are easy to be eroded), much oil (including mechanical oil) and
steam;
• Places where organic substance solvent is used; where special spray is frequently used;
• Places where machines generate the high frequency electromagnetic wave (abnormal condition
will appear in the control system);
• Places where there is high humidity exists near the door or windows (dew is easily formed).
Warning:
Protect the machine from gales or earthquake, make the installation according to the regulations.
Improper installation will cause accidents due to the overturn of the air conditioner.
1
4
4
4 For unit suspension
1
4 For paper pattern of installation
2
1
1
6
For gas pipe
For liquid pipe
For pipe cover
For drainage pipe
For drainage pipe