Carrier 40VU007-7G-QEE Installations- Und Bedienungsanleitung Seite 18

Installation Procedures
Installation of panel
Bolt used should be close to panel
Air supply outlet is easy to be damaged, please pay attention to it when working.
1.Use drawing block to confirm the height of unit and size of ceiling. Remove it before installing
panel, as well as air return panel.
Method to dismantle the air return panel
2. Screw 4 installation panels 5mm in unit panel.
3. Fix the panel.
4. Tighten the screws.
5. Link the joint of louver motor (white, 2P) (unit without louver automatically running function
does not need this step).
6. If you want to use the remote controller, you need to prepare an additional remote-control
receiver (RE-02), the ten-pin white connector is for remote controller connect the port
CN21 on PCB.
7. Use remote control to make sure the connection is OK, and then cut off the power for 10
seconds, restart.
12