Zanussi ZOHEA3X1 Benutzerhandbuch Seite 25

Step 5 Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
Step 6 Pull the door trim to the front to remove
it.
Step 7 Hold the door glass panel by its top
edge and carefully pull it out. Make
sure the glass slides out of the sup-
ports completely.
Step 8 Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the dish-
washer.
Step 9 After cleaning, install the glass panel
and the oven door.
The screen-printing zone must face the inner
side of the door. Make sure that after the instal-
lation the surface of the glass panel frame on
the screen-printing zones is not rough when
you touch it.
When installed correctly the door trim clicks.
Make sure that you install the internal glass
panel in the seats correctly.
HOW TO REPLACE: LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
Step 1
Turn off the oven. Wait until the
oven is cold.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the lamp.
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
2
B
Put a cloth on the bottom of
the cavity.
1
A
Step 3
25